KleanStrip ETPO123B, Bulldog Adhesion Promoter
- This is a 15 oz Aerosol not a 12 oz Aerosol
Makes Paint Stick - To all Automotive Surfaces
Bulldog Adhesion Promoter is specially formulated to promote adhesion to all automotive painted or primed surfaces, even problem plastics. Bulldog Adhesion Promoter works well on all flexible or rigid plastics, fiberglass, aluminum, glass, chrome, vinyl, and painted surfaces. Bulldog acts as a tie coat by allowing several different surfaces to be painted at the same time to ensure a smooth, flawless, durable finish every time.
Directions for using Bulldog Adhesion Promoter:
For best results apply Bulldog Adhesion Promoter at a temperature above 60° F while avoiding direct sunlight and strong breezes.
Surface Preparation:
First clean areas to be repaired with Klean-Strip PrepAll Wax & Grease Remover. Then, thoroughly clean with Bulldog Abrasive Cleaner. Rinse completely with water and let the part dry. When repairing peeling painted surfaces, all peeling or loose paint must be removed. To blend repaired areas with the original paint, sand the surface and the surrounding paint with 400 grit wet sandpaper until a smooth surface is acheived. If the paint chips while sanding, it may be necessary to strip and repaint the entire part.
To Apply Bulldog Adhesion Promoter:
Shake Bulldog gently for at least one minute to secure a uniform mixture. Looks hazy, dries clear. Hold the can in upright position about 10-12 inches from repair area. Point arrow on button away from you and spray the surface with a light mist coat. Wait 3 to 5 minutes and apply a second light mist coat. Use steady,even strokes while spraying. Avoid heavy coats of Bulldog to minimize runs. If Bulldog runs, wipe down with lacquer thinner and reapply as directed. When doing spot repairs, apply Bulldog to the surrounding blend-out areas. Any solvent base automotive paint should be compatible with Bulldog and can be applied after about 20 minutes up to about 16 hours. After 16 hours another coat is recommended.
