KleanStrip QTP0123, Bulldog Adhesion Promoter, Quart
MAKES PAINT STICK
To all Automotive Surfaces
BULLDOG ADHESION PROMOTER is designed to promote paint adhesion to all automotive surfaces even problem plastics. Bulldog Adhesion Promoter works equally well on all flexible or rigid plastics, fiberglass, aluminum, glass, chrome, vinyl, galvanized metal, and painted surfaces. Bulldog acts as a tie coat by allowing several different surfaces to be painted at the same time to assure a smooth, flawless, durable finish every time.
View a close up of the Bulldog Adhesion Promoter Label
MSDS Information
Salesman Note: Bulldog Adhesion Promoter is a quality product that aids in adhesion for paint on many types of surfaces.
KleanStrip Bulldog Adhesion Promoter Directions:
For best results apply Bulldog Adhesion Promoter at a temperature above 60 degrees F and away from direct sunlight and strong breezes.
SURFACE PREPARATION:
For best results, first clean all areas to be painted with Klean-Strip PrepAll Wax & Grease Remover. Then, thoroughly clean with Bulldog Abrasive Cleaner. Rinse completely with water and let the part dry. When repairing peeling painted surfaces, all loose and peeling paint must be removed. To blend repaired areas with the original paint, sand the surface and the surrounding paint with 400 or finer grit sand paper until a smooth junction is attained. If the paint chips while sanding, it may be necessary to strip and repaint the entire part.
To Apply Bulldog Adhesion Promoter:
Directions: Using a spraygun, apply an even, light mist coat. Wait 3-5 minutes and apply a second coat. Wait 15 minutes before applying the paint or primer but not longer than.
CLEANUP:
After each use of KleanStrip Bulldog Adhesion Promoter, All tools and spills should be cleaned immediately with lacquer thinner. Care should be taken to keep from exposing freshly painted surfaces to solvents.
* NOT AVAILABLE IN THESE STATES: CA, SC, DE, MD, UT
